Hello Ladybug

Hello Ladybug

All images © 1990-2022 Stampin’ Up!®

 

 

 

Supplies: 

• Stamp Sets: Hello Ladybug (157693) or Bundled (157699)

• Card Stock and Paper: Thick Basic White (159229); Basic Black (); Flowering Fields 12” x 12” Designer Series Paper - DSP (157670) 

• Stamp Pads: VersaMark (102283); Granny Apple Green (147095)

• Tools: Layering Circles Dies (151770); Stampin’ Cut & Emboss Machine (149653); Ladybug Builder Punch (157698) or Bundled (157699); Paper Trimmer (152392); Heat Tool (129053)

• Miscellaneous: Stampin’ Dimensionals(104430); Stampin’ Seal Adhesive (152813); Mini Glue Dots (103683); Playful Pets Twin Combo Pack(152466); Black Matte Dots (154284); White Embossing Powder from the from the Basics Embossing Powders (155554)

 

Measurements:

 

• Basic White: 8 ½ X 5 ½ scored at 4 ¼ and burnished with the Bone Folder, remainder of sheet for stamping and die cutting.

• Basic Black: 3 ¾” x 5”, ¾” x 3” for sentiment and 2 ½” x 2 ½” scrap for ladybug.

• Flowering Fields DSP: 3 ½” x 4 ¾” of Crushed Curry design and 2” x 2” piece of Poppy Parade dotted design.

 

Instructions:

 

1. Attach Basic Black cardstock to card base with Stampin’ Seal Adhesive.

2. Cut the largest circle from Thick Basic White cardstock using the Layering Circles Dies.  Attach to the Flowering Fields DSP using Stampin’ Seal Adhesive, near the bottom and hanging a little bit over the edge.  Trim the overlap even with the DSP using the Paper Trimmer.

3. Stamp leaf onto trimmed circle using the Hello Ladybug stamp set and Granny Apple Green ink. Attach DSP with circle to Basic Black Layer.

4. Heat emboss the sentiment onto ½” x 3” scrap of Basic Black cardstock using VersaMark, white embossing powder and Heat Tool. Attach to card with Stampin’ Dimensionals.

5. Punch ladybug from Basic Black cardstock and wings from the Poppy Parade dotted piece of DSP.  Tie black and white twine around ladybugs neck and attach to card with Stampin’ Dimensionals.

6. Add three Black Matte Dots.