Rainbow of Happiness

Rainbow of Happiness

All images © 1990-2022 Stampin’ Up!®

 

Supplies:

• Stamp Sets: Rainbow of Happiness (157727)

• Card Stock and Paper: Card Stock(CS) Basic White (159276); Designer Series Paper (DSP) Sunshine & Rainbows

• Stamp Pads: Bermuda Bay (147096)

• Tools: Brilliant Rainbow Dies(157726); Paper    Trimmer (152392); Gingham Embossing Folder (157627); Stampin’ Cut & Emboss Machine(149653)

• Miscellaneous: Rhinestone Basic Jewels (144220); Stampin’ Dimensionals(104430); Stampin’ Seal Adhesive (152813)

 

Measurements:

 

• Base of Basic White 5 ½” X 8 ½”

• Striped DSP from Sunshine & Rainbows 4” x 5” and strip 5/8” x 3 ½”

• Basic White layer 4” x 4”; strip 3/8” x 3 ¼”; scraps for clouds

• Sunshine & Rainbows large rainbow cut out of DSP and centered: 2 ¼” x 3 ¼”

 

Instructions:

 

1. Score base at 4 ¼” on long side and crease with bone folder.  This is a horizontal card.

2. Adhere the 4”x5” piece of DSP centered on the front of the card base.

3. Run the 4”x4” piece of Basic White through the Cut & Emboss Machine using the Gingham Embossing Folder.  Then run through cutting out the Rainbow placing die as shown in picture allowing room for the sentiment below it.  You can also cut out two clouds on your scrap at the same time.

4. Place dimensionals on the front of the Rainbow DSP piece – one in each corner – and center the die cut rainbow piece over the top of it so colors show through.  Then add dimesionals to the back of this embossed layer and center if on top of the striped DSP on card front.  Add the two clouds as show with dimensionals.

5. Stamp sentiment on the strip of Basic White with Bermuda Bay ink.  Layer this onto the striped strip of DSP and then onto the front of the card as shown.

6. Add 5 small Rhinestone Basic Jewels to the front as shown in picture.